How To Clean A Sunbeam Steam Iron

• Contents
• Table of Contents
• Troubleshooting
• Bookmarks

Quick Links

/MD

®

®

Sunbeam

Turbo Steam

Iron

Instruction Manual

MD

MD

Fer Turbo Steam

Sunbeam

Notice d'emploi

www.sunbeam.ca

P.N. 174785

  Related Manuals for Sunbeam Turbo Steam

  Summary of Contents for Sunbeam Turbo Steam

• Page 1 ® ® Sunbeam Turbo Steam Iron Instruction Manual Fer Turbo Steam Sunbeam Notice d'emploi www.sunbeam.ca P.N. 174785...
• Page 2 – there may be hot water in the reservoir. • I f the iron is not operating normally, disconnect from the power supply and have the iron serviced by an authorized service center or call Customer Service at 1 800-667-8623. • Y our SUNBEAM iron is designed to rest on the heel rest. Do not leave the iron unattended. ®...

• Page 3: Features

  eatures 1. SPRAY MIST Nozzle 2. Covered Water Fill Hole 3. Digital Fabric Selection Display 4. Steam Lever 5. Mode Button 6. SHOT OF STEAM ® / Vertical Steam Button 7. SPRAY MIST Trigger 8. Soft Grip Handle 9. 360° Swivel Cord 10.

• Page 4: Using Self-Clean Future

  (continued) pecIal eatures ® hot oF team eature provides an extra burst of steam for deep penetration of stubborn wrinkles. You can use this feature while Dry or Steam ironing as long as the Fabric Select Dial is set to wool, cotton, or linen.

• Page 5: Anti-Calcium System

  (continued) aIntaInIng 5. Turn off and unplug iron. Holding iron over a sink in a horizontal position, press Self-Clean Button and hold. Water will begin dripping from the steam vents. Slowly rock iron side to side and front to back for 30 seconds. Dip nose of the iron slightly below the rear to circulate water.

• Page 6: Troubleshooting

  (continued) ronIng IRONING PANTS • Begin with the waistband and inseam area, then pockets and cuffs. • Pull waistband on pointy end of the board, as if you're "dressing" the ironing board. Iron upper-front part of the pants, including the waistband. • Place pants parallel to ironing board lengthwise so both legs are facing the same direction. Iron each leg by moving the iron back and forth along the pant leg. • Take cuff of the leg and bring it over towards the waistband to iron the inner part of the leg. Repeat these 2 steps for the second leg. Trouble Shooting PROBLEM CAUSE/SOLUTION "Power" indicator light is blinking and • The red light blinks and beeps 6 times to indicate that the iron auto- fabric setting light is off off function has been activated.

• Page 7: How To Obtain Warranty Service

  1.800.667.8623 and a convenient service center address will be provided to you. In the U.S.A., this warranty is offered by Sunbeam Products, Inc. doing business as Jarden Consumer Solutions located in Boca Raton, Florida 33431. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20 B Hereford Street, Brampton, Ontario L6Y 0M1.
• Page 8 ©2014 Sunbeam Products, Inc., doing business as Jarden Consumer Solutions. All rights reserved. In the U.S., distributed by Sunbeam Products, Inc., doing business as Jarden Consumer Solutions, Boca Raton, FL 33431. In Canada, imported and distributed by Sunbeam Corporation (Canada), Limited, doing business as Jarden Consumer Solutions, Brampton, ON L6Y 0M1.

How To Clean A Sunbeam Steam Iron

Source: https://www.manualslib.com/manual/854415/Sunbeam-Turbo-Steam.html

Posted by: pierremagards.blogspot.com

Share this post